EccoFatto
EccoFatto is an ideal product for checking and trouble shooting the installation of systems based on DMX-ART NET-DALI and SPI. This equipment allows you to test all the protocols mentioned at the hardware level, without the need to connect expensive consoles or more advanced systems, it also becomes a HOT SPOT wifi that allows you to connect to its network to be able to remotely access all the commands available on the equipment . In all operating modes as Master device it sends the values of the sliders on all protocols, in case of DALI up to a maximum of 64 sliders, on the DMX 512 slider, on the SPI 240 maximum slider, the channels are accessible via the arrows on the cursor that move the slider bank to the left or right. It is also possible to use EccoFatto as ART NET so through the console that generates ART NET in wifi this can be managed as a Gate Way towards SPI-DALI-DMX, always active but managed by ART NET, or it is possible to use EccoFatto as an ART NET wifi generator in master mode and can control other ART NET nodes connected to him in Broad Cast. Normally EccoFatto can also be connected to a PC via USB cable and can use our software Ecco, Esuite and Mecco, as a PC- to DMX, DALI, SPI interface , using the supplied USB cable EccoFatto. EccoFatto has a battery capable of powering it for 10 hours of work at full operational capacity, which is then recharged in 12 hours with the appropriate USB cable and power supply supplied in the package. EccoFatto in use as DALI master does not power the bus for this you need a compatible DALI power supply not included. EccoFatto can be updated via WIFI by connecting in HotSpot mode using the commands available on the web screen. The HotSpot function is the easy way to use adn it does not require any APP, and can be connected via the WEB, with any device and operating system as long as they use a Web Browser.�